NorvattMini UPS & Battery Backup
English

Product Family

USB step-up cables

FAMILY — 2 MODELS

The simplest backup in the range has no battery at all: a cable that steps USB 5V up to the 9V or 12V a router actually needs, so any USB power bank becomes an emergency router supply. Two models cover the two common router voltages; both are 800 mm long with overcurrent protection built in.

Illustration of a USB step-up cable with USB and barrel plugs

When a cable beats a UPS

A step-up cable makes sense when a power bank is already on hand and the load is light — a single router draws 0.5A or less at 12V in typical use, inside the cable's 6W envelope. For automatic, always-connected backup the mini UPS families remain the right tool; the cable is the low-cost bridge for occasional outages and travel kits.

Converters, not batteries

Everything on this page converts; nothing here stores. A step-up cable takes a USB power bank's 5V and presents the 9V or 12V a router expects, at its rated output, which makes the cable exactly as capable as the bank behind it — no more, in either direction. That honesty defines the family's place: the emergency bridge and the travel kit, the drawer and the van, anywhere a bank already exists and a network device needs temporary rescue.

The two label checks

Compatibility with either cable is settled by two readings of the device's own label: its input voltage must match the cable's output exactly — 9V devices to the 9V cable, 12V to the 12V, with no optimism in either direction — and its rated draw must sit inside the cable's output rating with room for the startup surge. Routers and modems in the common classes pass both checks as a matter of routine; anything with a motor or a heater should be asked about first.

Labelling, kits and fleets

Installers who maintain mixed estates buy these cables as kit, and kit discipline is labelling: the two cables are told apart by their printed rating, and a cable marked at both ends with its voltage survives the 2 a.m. swap that an unmarked one fails. Fleet inquiries should state the estate's device classes and the kit's intended contents; the reply can confirm the rating fit across the estate in one pass and flag any device class that belongs on a purpose-built UPS instead.

Illustration of a cable with a barrel connector

Step-up cable 5V to 12V

USB 5V in, DC 12V 0.5A out, 6W maximum — for 12V routers and modems.

12V 0.5A · 6W

See the model page →

Illustration of a cable with a barrel connector

Step-up cable 5V to 9V

USB 5V in, DC 9V 0.5A out, 4.5W maximum — for 9V routers and modems.

9V 0.5A · 4.5W

See the model page →

Related pages

Ask for a quotation

Tell us the model, the output voltages your equipment needs and the quantity band for your order. If you are matching a UPS to a router, camera or terminal, add the device's rated voltage and current.

Send an Inquiry